Solar Sun Rings - Patterned 5' Round Passive Solar Pool Heating

The Solar Sun Ring is a passive solar swimming pool heating device made from two sheets of heavyweight U.V. resistant vinyl. The upper clear layer holds insulating air and focuses sunlight on the blue colored lower layer. The blue layer absorbs about 50% of the sunlight and converts it to heat. The balance of the sunlight is allowed to pass through for deep water heating.

Common Questions:

How Do Solar Sun Rings Work?

At night the contained air acts as an insulating blanket to retain heat gained during daylight. Solar Sun Rings are equipped with six magnets to facilitate rafting. The strength of the magnets will permit single position removal but will easily separate to prevent entrapment in accidental falls. Solar Sun Rings were designed to be compatible with automatic pool cleaners. In the event the suction hose catches on a ring, the ring will separate from the raft to allow the pool cleaner to continue.

Neither water nor pool chemicals can evaporate through the Solar Sun Rings two layers of heavyweight vinyl. You will save water and chemicals about equal to the percentage of the surface covered. Once the water in your pool has reached adequate temperature, Solar Sun Rings may be turned over to conserve water by limiting evaporation without significantly heating the water.

Are Solar Sun Rings Compatible With My Pool?

Solar Sun Rings may be used on all chlorine or salt water system pools, whether in ground or above ground.

How Do I Clean My Solar Sun Rings?

After removal from the swimming pool Solar Sun Rings can be easily cleaned with a sponge and mild detergent solution. Your pool requires some direct sunlight and open water to stay healthy. The open water around the raft of Solar Sun Rings and the triangle caused by the convergence of three Solar Sun Rings is by design. These open areas allow your pool to receive some direct sunlight. This sunlight will greatly reduce the incidence of mustard algae.

How Many Solar Sun Rings Do I Need?

We recommend enough Solar Sun Rings be purchased to cover 70% to 80% of your pools surface, ignoring the small triangles between the rings.