FREE Standard Shipping On All Orders $100 Or More! *
U.S. Motors - Emerson ASB130 C-Flange 2HP Full Rated 56J 230V Pool and Spa Motor
$369.99
The U.S. Motors Emerson ASB130 C-Face 2HP Full Rated 56J 230V Single Speed Pool and Spa Pump Motor is a powerfully designed replacement motor.
More Details
Membership Available
The U.S. Motors Emerson ASB130 C-Face 2HP Full Rated 56J 230V Single Speed Pool and Spa Pump Motor is a powerfully designed replacement motor.
- Shaft Threads - 7/16-20 UNF-2A
- 50 Degree C Ambient
- 1081 Design
- Continuous Duty
- Class B Insulated
- 303 Stainless Steel Shaft
- Thermally Protected
- Service Factor: 1.2
- RPM: 3450
- Shaft: Threaded
- Length without Shaft: 11.77
- 10.5A 230V
- Ensure the pool motor is compatible with your pool pump.
- Turn pump power off during replacement.
- Check voltage requirements on your current setup.
- Always replace the mechanical pump seal. It's recommended to replace all gaskets when replacing the motor.
- Turn on the pump to test for leaks and pump operation.
- Please reference additional installation instructions in owner's manual in Guides and Documentation section below.
- Please Note: We recommend professional installation or the manufacturer warranty may be void. See Warranty section below.
The U.S. Motors Emerson ASB130 C-Face 2 HP Full Rated 56J 230V Pool and Spa Pump Motor is a powerfully designed replacement motor.
Similar to spa and pool replacement motors, the Emerson 56 C-Flange Motor is a two-compartment model with a voltage selection device, running at 2HP and 230V. It is Class B-insulated for efficient operation and has been designed with both sealed ball bearing sand triple bearing protection. The Emerson replacement motor has an open drip-proof design for water damage prevention and is thermally protected.
Please Note: When replacing the motor on the pump, replacing the mechanical pump seal is required to ensure proper installation. Pump seal size varies depending on the pump and not the motor.
Similar to spa and pool replacement motors, the Emerson 56 C-Flange Motor is a two-compartment model with a voltage selection device, running at 2HP and 230V. It is Class B-insulated for efficient operation and has been designed with both sealed ball bearing sand triple bearing protection. The Emerson replacement motor has an open drip-proof design for water damage prevention and is thermally protected.
Please Note: When replacing the motor on the pump, replacing the mechanical pump seal is required to ensure proper installation. Pump seal size varies depending on the pump and not the motor.
See Owner's Manual for details